Does the DEMO output any DMZ instructions? - MADRIX Forum

Does the DEMO output any DMZ instructions?

Post Reply
User avatar
GRIFFCOMM
Posts: 3
Joined: Mon Nov 12, 2018 6:15 am
Contact:

Does the DEMO output any DMZ instructions?

Post by GRIFFCOMM » Thu Nov 15, 2018 11:31 pm

Hi

I was tasked with testing Madrix against Pharos, so i have a DEMO of Madrix installed (version 5). We have a test DMXKing ePro 1, the DMXKing talks with the fixture (the DMXKing software has a test environment and it pushes commands over DMX so the fixture changes).

Its a static IP address on ArtNET 1 (0x0000), Madrix finds the ePro with the correct IP address it has listed ArtNET 0x0000 and shows it as universe 1 as output, however no matter what we do in Madrix i cant get ANY light output, nothing is going through the DMXKing, so does the Madrix demo actually push anything?

Typo above, should be DMX (been working on DMZ most of the day)
Many Thanks
Ashley

© Copyright 2018 - www.griffcomm.ca

Guertler
Support
Posts: 600
Joined: Tue Feb 04, 2014 10:47 am

Re: Does the DEMO output any DMZ instructions?

Post by Guertler » Fri Nov 16, 2018 11:11 am

Hello GRIFFCOMM,

The Demo Version of MADRIX 5 will not output any data to the connected Art-Net node. To unlock the output of MADRIX 5 you will need a least a MADRIX 5 KEY start.

Post Reply
cron
Back to top