Question regarding data cabling
Posted: Tue May 13, 2025 12:08 am
Folks, I've got the following setup:
We are using MADRIX NEBULA controllers. I understand that ideally we'd do a snake data cabling, so start with the top strip to the right. Cable from the left end of the top stripe to the left end of the second from top. Then cable from the right end of the second from top to the right end of the third from top and so on.
However, is there any way to inject data into each stripe on the same side (e.g. the right end of each row)?
We are using MADRIX NEBULA controllers. I understand that ideally we'd do a snake data cabling, so start with the top strip to the right. Cable from the left end of the top stripe to the left end of the second from top. Then cable from the right end of the second from top to the right end of the third from top and so on.
However, is there any way to inject data into each stripe on the same side (e.g. the right end of each row)?