TM1814 configuration

Post Reply
bition
Posts: 2
Joined: Mon Apr 01, 2019 10:03 pm

TM1814 configuration

Post by bition »

Hi dear community,

I am new to MADRIX and I want to setup some LED light for a smarthome illumination with the MADRXI Nebula.

I have found a very nice LED strip with an IC TM1814. I tried to configure this LED strip since a few days in the MADRIX software, but without success. Here are some pictures of the setup.
MADRIX Nebula hardware confuguration
TM1814 LED strip configuration
control settings in software

With this settings I could not getting work the LED strip. The strip rotate in colors immediately when it gets the 24V supply like in this video. But the control in the MADRIX software is set to off (mono black).

What is wrong with my configuration?
I would be happy, if someone could help me.

Greetings,
bition
Fritzsche
Support
Support
Posts: 716
Joined: Mon Oct 05, 2009 5:26 pm
Contact:

Re: TM1814 configuration

Post by Fritzsche »

Hi bition,

I would recommend that you contact us by e-mail or phone. Thank you!
–––
Hallo,
magst du uns vielleicht über Telefon oder E-Mail kontaktieren? Das geht sicherlich einfacher. Danke sehr!
bition
Posts: 2
Joined: Mon Apr 01, 2019 10:03 pm

Re: TM1814 configuration

Post by bition »

Hi Fritzsche,

thank you for you quick response an sorry for my delay.

I have got some support from the LED strip supplier, because I have had some mistakes in the connection of the LED strip. I have tried to control the strip via SPI from the wrong end of the strip. When I use the correct end, it works perfectly with the Madrix Nebula.

Greetings,
bition
Post Reply
Back to top