MADRIX Forum • TM1814 configuration
Page 1 of 1

TM1814 configuration

Posted: Mon Apr 01, 2019 10:35 pm
by bition
Hi dear community,

I am new to MADRIX and I want to setup some LED light for a smarthome illumination with the MADRXI Nebula.

I have found a very nice LED strip with an IC TM1814. I tried to configure this LED strip since a few days in the MADRIX software, but without success. Here are some pictures of the setup.
MADRIX Nebula hardware confuguration
TM1814 LED strip configuration
control settings in software

With this settings I could not getting work the LED strip. The strip rotate in colors immediately when it gets the 24V supply like in this video. But the control in the MADRIX software is set to off (mono black).

What is wrong with my configuration?
I would be happy, if someone could help me.


Re: TM1814 configuration

Posted: Tue Apr 02, 2019 11:21 am
by Fritzsche
Hi bition,

I would recommend that you contact us by e-mail or phone. Thank you!
magst du uns vielleicht über Telefon oder E-Mail kontaktieren? Das geht sicherlich einfacher. Danke sehr!

Re: TM1814 configuration

Posted: Wed Apr 10, 2019 10:20 pm
by bition
Hi Fritzsche,

thank you for you quick response an sorry for my delay.

I have got some support from the LED strip supplier, because I have had some mistakes in the connection of the LED strip. I have tried to control the strip via SPI from the wrong end of the strip. When I use the correct end, it works perfectly with the Madrix Nebula.