MADRIX Forum

Hello jremy, Welcome to the MADRIX forum. I tried to reproduce the explained problem but wasn't able to. Can you please double check at your setup if MADRIX is always receiving the "Note Off" command from the connected "Akai - APC 40 mk II". That means always when you release the...

Hello ChrisCotton, At the moment MADRIX dosen't provides the possibility to re-address selected fixtures automatically. But I will add this request to the feature wishlist. For the elaborated problem in this post you can use the "Undo" function of the Patch Editor or double check if MADRIX...

Hello r2.lighting, The easiest way would be to connect the audio interface input of the used MADRIX PC with an additinal audio output of the used DJ console. If you want to use a digtial connection you would need to find a kind of "virtual converter" software which converts the digital aud...

Hello RockitFX, To increase the render frame rate in MADRIX simply open the "Options" (Preference > Options) and activate the "Performance" tab. For the output it depends which data will be send. For all DMX based protocols like Art-Net, sACN, KiNet or DMX you can change the sett...

Hello guys, The MAC address is part of the so called Art-Net PollReply package of Art-Net nodes. According to your explanation it sounds like Resolume is sending a Art-Net PollReply as soon as it was started. The MADRIX in the same network receives and interprets it. It also sounds like the received...

Hello RockitFX, For the Strobe MADRIX is using the color channels of the fixtures which are set to on and off. Depedning on the set render and output frame rate the strobe can be more or less fast. That also means if the frequency will be too high frames can be dropped which results in the explained...

Hello PLebegue,

The error 0x80070003 means the required file can not be found for a task or the path is invalid.
Please double check the file path or is it saved at a cloud where the connection needs to be established first?

Hello mcastrigno, According to the DMX standard it is a streaming protocol which sends continuously data. It is not possible to send only a DMX value if the received V+ value will be changed. Maybe you can elaborate a bit more in detail what you want to acchive and which application is the receiver ...

Hello mcastrigno, The explanation in the example above refers to the Measure Function "Digital (Hysteresis Threshold)" and not "Signal Slope Detections". In case of the Measure Function "Signal Slope Detections", the ORION will measure the input voltage once per second ...

Hi mcastrigno, You are totally right. The Measure Function "Digital (Hysteresis Threshold)" will change the DMX value of the desired DMX channel if the received voltage is higher or below the set limits. In your example: - If the voltage value is higher than 10 V, the DMX value will be set...